I installed a ZOOM 14.4 PC model 110 faxmodem and MS-Kermit 3.14 patch 0, but could not get error crrection (V.42, MNP2-4) or compression (V.42bis, MNP5) work. Here's what I did. I added an entry in dialups.txt, with speed set at 57600. Because the command AT &Q5 in modems\zoom.scr is not supported by this modem, I changed to AT &Q6 to select asynchornous mode with speed buffering. Then I dialed a V.32bis/LAMP/V.42bis modem using dial macro, the connection was 14400 without any protocols.
The manual of this faxmodem says: "This faxmodem uses RPI, the Rockwell Protocol Interface, to implement V.42 and MNP 2-4 error correction as well as V.42bis and MNP 5 data compression. The RPI-based implementation works just like built-in or harware-based V.42, V.42bis and MNP when you use it with RPI-compatable data communucations software. If you have a specific use that requires error correction and you can't use RPI-compatable software, you will need a faxmodem with built-in V.42 or MNP2-4 error cor
rection."
My question is if MS-Kermit 3.14 is RPI-compatable. If it is, what did I do wrong or what should do? If it is not, will it be?
